Filter
Top Products
Changing The Inner Light
Before removing the inner light, turn off the appliance first and then unplug the unit from the wall
outlet. Failure to do so could result in electrical shock or personal injury.
• Use Phillips screwdriver to take out the screw.
• Remove the transparent light cover gently.
• Pull out the existing light bulb by unscrewing it counter-clockwise.
• Insert new light bulb (E12, max. 15W) by screwing it in clockwise.
• Replace the transparent light cover and tighten screw.
Automatic Defrost
There is no need for manual defrosting of this appliance due to automatic defrosting function.
• The ice build-up on the inner back wall during compressor operation will be automatically
defrosted once the compressor cycle is off.
• Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan
located above the compressor, from where it evaporates.
CHANGING THE REVERSIBLE DOOR
This appliance is built with a reversible door. You have the choice of either opening it from the left or
the right side. In order to reverse the opening direction of your door, please follow these simple
instructions. NOTE: If desired, please change the door swing prior to appliance installation.
Caution: To avoid personal injury to yourself and/or property, we highly recommend that
someone assist you during the door reversal process.
1) Remove the top hinge assembly and keep
them for later use.
2) Remove the bottom hinge assembly and
keep them for later use.
3) Remove the plug buttons from the upper left
holes and transfer them to the uncovered
holes on the right side. Be sure to press the
plug buttons firmly into the hole.
4) Re-install the top hinge assembly previously
removed in step 1 on the opposite side.
5) Re-install the bottom hinge assembly
previously removed in step 2 on the
opposite side.
6) Re-install the door assembly with the door
handle on the opposite side. (Rotating the
door assembly 180°).
7) Ensure that the door assembly is properly
aligned with cabinet before tightening the
screws.
EN
8