Filter
Top Products
CARE AND CLEANING OF YOUR CHAMPAGNE CELLAR
Condenser
The condenser tubing inside the cabinet does not require
frequent cleaning; however, satisfactory cooling depends
on adequate ventilation over the coils. Be sure that noth-
ing obstructs the required air flow openings in front of the
cabinet. At least once or twice a year, brush or vacuum lint
and dirt from the condenser for efficient performance by
unscrewing the grille on the bottom front of the cabinet.
Cabinet
The stainless steel cabinet can be washed with either
a stainless steel cleaner or a mild soap and water and
thoroughly rinsed with clear water. NEVER use abrasive
scouring cleaners.
Interior
Wash interior compartment with mild soap and water. Do
NOT use an abrasive cleaner, solvent, polish cleaner or
undiluted detergent.
Roll-out Racks
Tha racks may be cleaned with mild soap and water and a
soft cloth. Do NOT use any abrasive cleaners.
Door Gasket
The vinyl gasket may be cleaned with mild soap and water,
a baking soda solution or a mild scouring powder.
Light Bulb Replacement
WARNING! DISCONNECT THE POWER CORD BEFORE
ATTEMPTING LIGHT BULB REPLACEMENT. Failure to do so
may result in an electrical shock that could severely injure
you.
This unit uses one, 6 watt light tube to illuminate the interi-
or of the champagne cellar. The light tube is a very reliable
electrical component, but should it not function properly,
please call the dealer you purchased your champagne cel-
lar from for a replacement light tube. Use only an original
equipment light tube from your dealer or Marvel Industries.
Do NOT under any circumstance use a light tube that
exceeds 10 watts!
To replace the light tube, use a hex-head driver to remove
the two (2) hex-head screws holding the old light tube in
place. Disconnect the electrical plug from the cabinet’s
electrical receptacle and discard the old light tube. Re-
connect the electrical plug of the the new light tube to the
cabinet’s electrical recepatacle. Make sure it is secure and
fully installed.
Using the hex-head driver, resecure the two (2) hex-head
screws to secure the light tube in place. Plug the cham-
pagne cellar into the electrical socket. Check to see if the
light tube operates properly. Your light tube’s replacement
is complete.
The light tubes are not covered by your warranty. Replace-
ment tubes can be obtained from your dealer or from
Marvel Industries.
In the Event of a Power Failure
If a power failure occurs, try to correct it as soon as pos-
sible. Minimize the number of door openings while the
power is off so as not to adversely affect the unit’s tem-
perature.
5