Filter
Top Products
7
Do NOT under any circumstance use a light bulb that
exceeds 15 watts!
To replace the light bulb, disconnect power to the unit. Un-
screw the old light bulb located behind the display housing
at the top of the unit. Set the old light bulb aside. Screw
the new light bulb into place. Reconnect the power to the
unit. Check to see if the light bulb operates properly to
complete the installation.
The light bulb is not covered by your warranty. A replace-
ment bulb can be obtained from your dealer or from
Marvel Industries.
In the Event of a Power Failure
If a power failure occurs, try to correct it as soon as pos-
sible. Minimize the number of door openings while the
power is off so as not to adversely affect the unit’s tem-
perature.
NOTE: If a power interruption occurs, the unit may take 5
to 10 minutes to restart.
Condenser
The condenser tubing inside the cabinet does not require
frequent cleaning; however, satisfactory cooling depends
on adequate ventilation over the coils. Be sure that noth-
ing obstructs the required air flow openings in front of the
cabinet. At least once or twice a year, brush or vacuum lint
and dirt from the condenser for efficient performance by
unscrewing the grille on the bottom front of the cabinet.
Cabinet
The painted cabinet can be washed with mild soap and
water and thoroughly rinsed with clear water. NEVER use
abrasive scouring cleaners.
Interior
Wash interior compartment with mild soap and water. Do
NOT use an abrasive cleaner, solvent, polish cleaner or
undiluted detergent.
Pull-out/Wire Racks
The racks may be cleaned with mild soap and water and a
soft cloth. Do NOT use any abrasive cleaners.
Glass Shelves
Use a glass cleaner or mild soap and water and soft cloth
to clean the glass shelves. Do NOT use any abrasive
cleaners.
Glass Door
Use a glass cleaner or mild soap and water and soft cloth
to clean the glass door model. Do NOT use any abrasive
cleaners.
Door Gasket
The vinyl gasket may be cleaned with mild soap and water,
a baking soda solution or a mild scouring powder.
Light Bulb Replacement
WARNING! DISCONNECT THE POWER CORD BEFORE
ATTEMPTING LIGHT BULB REPLACEMENT. Failure to do so
may result in an electrical shock that could severely injure
you.
The 3BARM and 6BARM use one, 15 watt incandescent
light bulb to illuminate the interior of the beverage center.
The light bulb is a very reliable electrical component, but
should it not function properly, please call the dealer where
you purchased your beverage center from for a replace-
ment light bulb. Use only an original equipment light bulb
from your dealer or Marvel Industries.
CARE AND CLEANING OF YOUR BEVERAGE CENTER