Filter
Top Products
STEP 3: Prepare The Venting Blower
12
Roof-Vented Installation:
1. Remove one blower unit mounting screw and one or two
blower plate screw(s). Remove the blower plate from cabinet.
See Figure 18.
2. Use side cutter or thin snips to cut and remove knockouts "A"
from Blower plate. Discard knockouts. Be careful not to distort
the plate. See Figure 19.
3. Carefully lift the blower unit out of the microwave oven.
4. Rotate blower unit 90° so the exhaust ports face the upper of
the cabinet. See Figure 20.
5. Reassemble the blower wire.
6. Place blower unit back into microwave oven.
7. Reattach blower plate to microwave oven. Attach with the one
blower unit mounting screw and then the one or two blower
plate mounting screw(s). See Figure 21.
8. Attach the exhaust adapter to the blower plate by sliding it into
the Guide. See Figure 22.
4. Reassemble the blower wire. See Figure 14.
5. Rotate the unit so that the exhaust ports face the rear of the cabinet. See Figure 16. When you insert blower unit,
blower wire must be like figure 15.
6. Place blower unit back into cabinet. Check that the exhaust ports face towards the rear of the cabinet. See Figure 16.
7. Reattach the blower plate to cabinet so the exhaust ports and blower plate opening are aligned. Attach with one blower
unit mounting screw and then one blower plate mounting screw. See Figure 17.
Figure 14
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20 Figure 21 Figure 22
exhaust
ports
blower
unit
exhaust
ports
blower plate
mounting screw
blower plate
back plate
blower unit
mounting screw
blower plate
mounting screw
blower plate
back plate
blower unit
mounting screw
blower plate
mounting screw
Exhaust
adaptor
Back
of oven
blower unit
blower plate
blower unit
mounting screw
blower unit
exhaust ports
blower unit
blower plate
parts “B”
Knockouts “A”
blower unit
blower
unit