Filter
Top Products
20
Maintenance
Oven Doors
Oven Windows
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or
other objects.
3. Do not close the oven door until the oven racks are in
place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
Upper and Lower Oven Lights
• Do not place excessive weight on or stand on open oven
doors. This could cause the range to tip over, break the
door, or injure the user.
• Do not attempt to open or close doors or operate oven
until doors are properly replaced.
• Never place fingers between hinge and front oven frame.
Hinge arms are spring mounted. If accidentally hit, the
hinge will slam shut against oven frame and could injure
your fingers.
Both the upper and lower oven doors are removable.
To remove:
1. When cool, open the oven door to
the broil stop position (opened
about four inches).
2. Grasp door at each side. Do not
use the door handle to lift door.
3. Lift up evenly until door clears
hinge arms.
To replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is
completely seated on the hinges. Push down on the top
corners of the door to completely seat door on hinges.
Door should not appear crooked.
Note: The oven door on a new range may feel “spongy” when
it is closed. This is normal and will decrease with use.
CAUTION
CAUTION
• Disconnect power to range before replacing light bulb.
• Use a dry potholder to prevent possible harm to hands
when replacing bulb.
• Be sure bulb is cool before touching bulb.
• Do not touch hot bulb with a damp cloth as this may cause
the bulb to break.
To replace oven light bulb:
1. When oven is cool, hold bulb cover in place, then slide wire
retainer off cover. Note: Bulb cover will fall if not held in
place while removing wire retainer.
2. Remove bulb cover and light bulb
(lower oven only).
3. Replace with a 40-watt
appliance bulb.
4. Replace bulb cover and
secure with wire retainer
(lower oven only).
5. Reconnect power to range. Reset clock.
BULB COVER
WIRE
RETAINER
Leveling Legs
ANTI-TIP BRACKE
T
LEVELING LEG
LEVELING LEG
CAUTION
Be sure the anti-tip bracket secures one of the rear
leveling legs to the floor. This bracket prevents the range
from accidentally tipping.
Be sure the range is leveled when installed. If
the range is not level, turn the leveling legs,
located at each corner of the range, until
range is level.
ANTI-TIP BRACKET