Filter
Top Products
Component Specifications
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to dishwasher before servicing,
unless testing requires it.
16023063 2 May 2004
©2004 Maytag Services
Illustration Component Test Procedure Results
Dishwasher Motor
CCW rotation only
viewed from shaft
end.
1/3HP
120V/60hz, 3.2 amps,
3250 RPM
Main Wattage, 285
watts
Start Wattage, 1115
watts
Measure resistance from
ST5 (Motor Common – blue) to ST8
(Motor Main - yellow). ..........................
See Component Specifications/Motor
Connections for details.
3 to 4 Ω
Control Board See Component Specifications/
Membrane Readings for
troubleshooting/pin-out instructions.
Water valve
120V/60hz, 7 watts
1.13 ± .10 gpm at 20-
120 psi
Measure resistance from
J6 Pin 4 Aqua (Float switch) to ST4
Black (Common) .................................
1.1 k Ω
(This value assumes the float switch is
closed).
Vent wax motor
120V with 1/4"
actuation stroke
within 60 seconds
Measure resistance from J6 Pin 1
Purple (Vent) to ST4 Black (Common)
1.2 k Ω
Dispenser wax motor
120V with 1/4"
actuation stroke
within 60 seconds
Measure resistance from J6 Pin 3
Tan (Dispenser) to ST4 Black
(Common) ..........................................
2 k Ω