Delay/Resume Control Lock Option
The Delay/Resume option can be used to automatically
start the cycle at a later time, such as during off-peak
hours for reduced energy cost or to reduce daytime heat
buildup in the home.
The control touchpads can be locked to prevent unwanted
use. If this feature is activated between cycles, the dish-
washer cannot be operated until the controls are unlocked.
If desired, the controls can be locked after a cycle or delay
has started.
To Set Up a Delay:
Select tile appropriate cycle and options for the load.
N Press the Dday/Resume pad until the desired
amount of delay time (1 to 9 hours) is selected. The
delay time will begin counting down when the pad
is released.
N The Dday/Resume indicator light will remain lit
until the delay time has counted down.
Setting the Control Lock:
Press the _ pad for three seconds.
N An indicator light above the pad will illuminate
when the controls are locked.
To Cancel:
The cycle will automatically start as soon as the
delay time expires. N Press the _ pad for three seconds.
i ' NTheindicat°rlightwillg°°ff
ToCancel.Del_y:
Wait at least 2 seconds, then press the Delay/Resume
pad again. The indicator light will go out and the cycle
will start or resume immediately.
Operating Tips .......................................................
Starting The Dishwasher Adding a Forgotten item
N Afterloadino--thedishwasherandaddingdetergent,Forbestcleaning,theforgottenitemshouldbeaddedearly
close the dishwasher by pressing the door until the ill the cycle.
latch clicks. _ Press the Delay/Resume pad or unlatch the door.
N To start the dishwasher, firmly press the desired N Wait for the water circulation to stop.
cycle and options pads. After a pause, the fill will
begin. To prevent unplanned cycle or option _ Open the door and add the item.
] changes, these selections are locked in after 1 _ Close and latch the door.
minute.
N The indicator lights for the selected cycle and • If Delay/Resume was pushed, push it again to
options will glow. restart the dishwasher.
To cancel an option, press the pad again. To cancel N After five seconds, the cycleresumes automatically at
a cycle, press the Drain/Off pad. the point of interruption.
th