A-3 16021814 Rev. 0 ©2002 Maytag Appliance Sales Company
Built-In Dishwasher
Installation Instructions
Leave Installation Instructions and User’s Guide with Owner
CAUTION: Disconnect electrical power before you start!
ALL ELECTRICAL WIRING, GROUNDING AND PLUMBING SHOULD BE DONE IN ACCORDANCE WITH
NATIONAL AND LOCAL CODES BY QUALIFIED INDIVIDUALS.
This dishwasher is designed for operation
on an individual 120 VAC, 60 Hz grounded
electrical circuit. Use required fuse (15 amp)
or comparable circuit breaker. Two wire
with ground service to the dishwasher is
recommended for connection at the terminal
box and for grounding.
GROUNDING INSTRUCTIONS
This appliance must be connected to a
grounded metal, permanent wiring system;
or an equipment-grounding conductor must
be run with the circuit conductors and
connected to the equipment-grounding
terminal or lead on the appliance.
PLUMBING REQUIREMENTS
CHECK LOCAL PLUMBING CODES
FOR APPROVED PLUMBING
PROCEDURES AND ACCESSORIES.
ALL PLUMBING SHOULD BE DONE
IN ACCORDANCE WITH NATIONAL
AND LOCAL CODES.
ELECTRICAL REQUIREMENTS
CAUTION: To prevent accidental contact with electrical
connections, built-in dishwasher models must not be
connected to a power source unless the dishwasher is
completely enclosed, with front panels in place. If the back
or either side of the dishwasher is exposed, a panel must
be used to complete this enclosure. Failure to follow this
warning could result in death or serious injury.
WARNING
CAUTION:To prevent the possibility of electrical shock,
this dishwasher, as other electrical appliances, must be
adequately grounded. It is the responsibility of the installer
at the point of installation, taking into consideration local
conditions and requirements. Failure to follow this warning
could result in death or serious injury
CAUTION: Disconnect electrical
power to dishwasher before you start!
Failure to follow this warning could
result in death or serious injury.
WARNING
WARNING