Filter
Top Products
240EdwardsStreet,SE
C[eve!andrTennessee3731;
Tel:423-472-3333
Fax:422-a78-6710
INSTALLATION OF PERIMETER TRIM
NOTE: Holes must be drilled in the face of the door to mount the lower H-trim piece. Work very carefully to
properly locate these mounting holes.
26. Carefully cut freezer door template from template sheet. Tape template to the face of the door so that the
edges of the template exactly line up with the edges of the door as printed on the template.
27. Install lower H-trim piece following Steps 12 and 13.
28. Install the escutcheon frame around the dispenser escutcheon with the textured surface up.
F-SCUTCHEOS
FRAME
J
29. Peel back three to four inches of the protective backing and crease to form pull tabs on the lower ends of
the two 1/4" U-shaped panel channels for the freezer door.
30. Position the longer 1/4" U-shaped panel channel so the end is against the lower H-trim and with soft nose
against the right side of the handle. Apply pressure to the "hard side" of the panel channel to slightly compress
the "soft nose" against the handle. Then press down firmly to insure proper tape bonding.
IMPORTANT: Once adhesive bonds to the door panel, it cannot be removed. Make sure that you align the
filler strip properly as you work towards the bottom of the door.
31. As you work up toward the escutcheon, pull the tape backing to expose the adhesive to the door panel.
Press down firmly to insure bond.
_ MA'_rAG Admiral 7| :I_im_ENN-A_ _'_]Mlagic C.het