Filter
Top Products
5
You can customize your cycle by selecting an option.
See option selections. If you change your mind, press the option again to turn off the option, or select a different option. You can change
an option anytime before the selected option begins.
*Maximum wash times depend on water temperature, heavy soil condition, dish load size and options selected.
NOTE: Dry time (fan running) is typically 4 hours after wash cycle. After 30 minutes of dry time, the clean light will illuminate. Anytime after
the clean light is lit and the drawer is opened for longer than 30 seconds, the cycle will be terminated.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
Use to quickly wash
prerinsed glasses or dish
loads.
This cycle does not dry. 0:30 none none
CYCLE SELECTIONS
CYCLES DISH LOAD TYPES DESCRIPTIONS WASH TIME (HH:MM)
Cycle
Minimum
Cycle + Options
Minimum
*Maximum
OPTION SELECTIONS
OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH:
Loads containing tough,
baked-on food.
Increases the target water temperature during the wash
portions of the cycle.
Adds heat, wash time and water to the cycle.
Sensor Wash, Heavy
Duty or Normal Wash
To run your dishwasher at
a later time or during off-
peak hours.
Delays the start of a cycle up to 6 hours.
Select a wash cycle and options. Press 6 Hour Delay. Press
START/RESUME. Close the drawer firmly.
All cycles, except Rinse
Only
Control Lock To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
To turn on Lock, press and hold Control Lock for at least
3seconds.
To turn off Lock, press and hold Control Lock for at least
3seconds.
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
3 times. The dishwasher drawer can be opened while the
controls are locked.
Anytime
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE COMMENTS
To start or resume a
wash cycle
If the drawer is opened during a cycle, a delay, or the power is interrupted, the Start/Resume
indicator flashes. To restart the drawer, open the drawer, press Start/Resume and close the
drawer firmly within 4 seconds.
To cancel wash
cycle
Close the drawer firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely. If the Cancel button is pressed a second time, the drawer will turn off.
To follow the
progress and status
of your dishwasher
cycle
Clean indicator glows when a cycle is finished.
Rinse aid low indicator light glows when the rinse aid dispenser needs to be refilled.