Filter
Top Products
Compact Refrigerators and Freezers Service and Installation Manual
For customer service, call (888) 732-2446 Fax (800) 669-0619, www.mccallrefrigeration.com
6
Door Hinge Reversal Instructions
Units with reversible doors will have 2 extra screws on the bottom of the door.
Follow these instructions to reverse the door hinging if applicable.
Disconnect power before beginning work.
Tip unit back and use a screwdriver to remove the bottom hinge pin. Note
that lock-tight was used during factory installation, so extra force may be
required to “break” the hinge pins loose.
Tilt door out from bottom and slide top pin out of the hinge bracket. Remove
top hinge pin.
Use a screwdriver to remove 2 screws and handle from top of door.
Flip door upside down. Remove two screws, then install the handle using the
screws removed in step 3.
Insert the 2 screws removed in step 4 into old screw locations.
Remove top and bottom hinge brackets from cabinet face.
Use templates (found on the next page) to locate holes as shown to the right.
Use a 1/8” drill for pilot holes being certain to drill through both the face frame
AND the metal backing plate.
Install top and bottom hinge brackets in new locations.
Install top hinge pin into top of door, then slide top door hinge pin into top
hinge bracket and close door onto cabinet face.
Install bottom hinge pin through bottom hinge bracket and into door.
Fill the holes in the face frame at original hinge locations with #10 sheet metal
screws (not provided).
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Top hinge template up
to unit nosing
Bottom hinge template
down to unit bottom