Melissa 146-007 Blender User Manual


  Open as PDF
of 29
 
18 19
18 19
KEY TO MAIN COMPONENTS OF THE
APPLIANCE
1. Motor section
2. Drive shaft
3. Safety lock
4. Lockpinsforplasticbowl
5. Suctioncupfeet
6. On/Off button
7. Cord with plug
8. Lidforblenderfunction
9. Safety lock pin
10. Plastic bowl
11. Blade for blender function
12. Tamper
13.Lidforgraterfunction
14. Grater attachment
15.Attachmentholderpin
16.Attachmentholder
17. Blade (grate/slice function)
18. Blade (grate/shred function)
19. Drive shaft port
20. Filling port
21. Spout
PRIOR TO FIRST USE
• Readthroughthesafetyinstructions
carefully.
• Beforeusingforthersttime,orafter
prolonged storage without use, wash
any parts that will come into contact
with food.
USING THE APPARATUS
1. Placethemotorsection(1)onaat
surface, e.g. a kitchen counter, and
makesureitstandsrmlyonthefour
suctioncupfeet(5)underneath.
2. Place the plastic bowl (10) down onto
the drive shaft of the motor section (2),
sothatthedriveshafttsintotheport
(19).
oMakesurethatthetwopartst
together properly. There should be
no gap between the bottom of the
bowl and the motor section.
o Turn the plastic bowl
counterclockwise so that the lock
pins (4) click into place and hold
it fast.
3. Fit the selected blender or grater
function components as described
below.
Use of blender function
1. Make sure that
the On/Off
button (6) is
set to “0” (off).
2. Mount the
blender
function blade
(11) onto the
drive shaft in
the middle
of the plastic
bowl. Make
sure that it is
pressed down as far as it will go.
3. Addfoodstuffstothebowl–onlyllthe
bowl approximately two-thirds full.
4. Place the lid (8) on the appliance, and
turn counterclockwise, so that the pin
(9) clicks into place in the safety lock
(3).
oMakesurethatthelidtstightly.
oNOTE:Thesafetylockensuresthat
the appliance cannot be turned on
if the lid or the safety lock pins are
notttedcorrectly.
5. Inserttheplug(7)inthemainssocket
and switch on the power.
6. Switch on the apparatus by switching
the on/off button to one of the following
settings:
o "CHOP" (lowest speed)
o"SLICE/SHRED"(highestspeed)
o"GRIND"(theapplianceonlyruns
as long as the On/Off button is held
at this setting).
7. Turn off the appliance by turning the
On/Off button to “o” and remove the
plug from the socket.
8. Wait until the blade has come to a
complete stock before removing the lid.
 previous next