Melissa 15009 Hot Beverage Maker User Manual


 
INTRODUCTION
Please read this instruction manual carefully and
familiarise yourself with your new travel jug kettle,
before using the first time. Please retain this
manual for future reference.
IMPORTANT SAFEGUARDS
- Close supervision is necessary when any
appliance is used by or near children.
- Before connecting the kettle, check if the
voltage indicated on the appliance (underside
of kettle) corresponds with the mains voltage
in your home. If this is not the case, contact
your dealer and do not use the kettle.
- Switch off and unplug from the outlet before
filling, emptying or cleaning, or when not in
use.
- Do not overfill as boiling water may be
ejected. The maximum and minimum level is
marked inside the kettle.
- Do not operate or place any part of this
appliance on or near any hot surface (such as
gas or electric burner or in a heated oven).
- Do not let the cord hang over the edge of a
table or counter. Do not let the cord touch hot
surfaces.
- Never yank on the cord as this may damage
the cord and eventually cause a risk of
electric shock.
- If the supply cord of this appliance is
damaged, it must only be replaced by a repair
shop appointed by the manufacturer, because
special purpose tools are required.
- Avoid touching hot kettle surfaces - use the
handle and knobs.
-To avoid possible steam damage, turn the
spout away from walls or cabinets when
operating the kettle.
- Extreme caution must be used when moving
the kettle containing hot water. Never lift the
kettle by its lid. Always use the body handle.
- To protect from electrical hazard, do not
immerse this kettle or cordset in any liquid.
BEFORE FIRST USE
- Before first use, it is recommended that you
fill the kettle with water and boil.
- Open the lid and fill the kettle with water to
the MAX mark indicated inside the kettle.
- Plug in the appliance and turn on the kettle on
"I". The control light switches on.
- When the water is boiling the kettle will cut off
automatically. Discard the water.
- Let the kettle cool off for approx. 3 minutes,
repeat the procedure 3 times.
INSTRUCTIONS FOR USE
- The kettle should always be unplugged when
filling or adding water.
- Fill the kettle with water to the desired level
between the MIN and MAX level indicator
inside the kettle. Do not overfill or there will be
a risk of spillage or spitting.
- Plug in the appliance and turn the kettle on.
The control light switches on. When the water
is boiling the kettle will automatically switch
off.
- If you wish to re-heat the water, let the kettle
cool off for 3 minutes before proceeding.
- Press the "O" button to switch off the heating,
the control light switches off.
- An automatic safety cut-out has been fitted
for protection against overheating. It will
operate if the kettle is switched on when
containing insufficient water or no water at all.
AFTER USE
- Disconnect the appliance from the outlet and
let the kettle cool off before storing.
WARNING
- Make sure that the plug and cord always are
dry.
HOW TO CARE FOR YOUR KETTLE
- Wipe the exterior of the kettle with a soft,
damp cloth or sponge.
- Remove stubborn spots with a cloth
moistened with mild liquid detergent.
- Do not use abrasive scouring pads or
powders. Never immerse the kettle in water or
othe liquids.
UK
645139_IM 15/08/05 9:40 Side 8