Filter
Top Products
PRODUCT DESCRIPTION:
1. Spout
2. Lid
3. Water level
indicator
4. Control lamp
5. On/Off button
6. Contact
7. Base with cord
storage
INSTRUCTIONS FOR USE:
- Before first use, fill the kettle with clean water
to maximum capacity and boil. Discard the
water and repeat.
- The kettle should always be unplugged when
filling or adding water.
- Fill the kettle with water to the desired level.
Do not overfill or there will be a risk of
spillage or spitting. The water level indicator
will assist you to measure correct amount.
You can fill the kettle via the spout or after
opening the lid. Do not forget to close the lid
after filling otherwise the kettle will not
automatically switch off after use.
- Do not fill with less that 0,35 litre of water.
- Do not fill with more than 1,2 litres of water
(up to "MAX" indication).
- An automatic safety cut-out has been fitted
for protection against overheating. It will
operate if the kettle is switched on when
containing insufficient water.
- If the automatic safety cut-out has operated,
switch the kettle off, disconnect from the
power outlet and allow the kettle to cool
down for 5- 10 minutes. Then refill with water
and switch on - the kettle will then boil and
cut off as in normal operation.
- The kettle may be switched off at any time
by either pushing the switch of the kettle to
the "up" position or by switching the power
off at the power outlet.
-To pour water, lift the kettle from the power
base and pour
CORDLESS KETTLE:
- Place the power base on a dry, flat surface.
- Place the kettle on the power base. The
electrical connections will be made
automatically as the kettle slides onto the
power base.
- Plug the cord into an eathed power socket
and switch on by depressing the switch of
the kettle to the "down" position.
- When the water has boiled, the kettle will
switch off automatically. After allowing the
kettle to cool down for 30 seconds, the water
can be brought back to the boil by pushing
the switch back to the "down" position.
During the cooling down time do not force
the on/off switch into the "down" ("ON")
position as this can damage the operating
mechanism.
- Do not remove the kettle from the power-
base without first switching off.
- The kettle may be switched off at any time
by either pushing the switch of the kettle to
the "up" position or by switching the power
off at the power outlet.
-To pour water, lift the kettle from the power
base and pour.
HOW TO CARE FOR YOUR KETTLE:
Wipe the exterior of the kettle with a soft, damp
cloth or sponge. Remove stubborn spots with a
cloth moistened with mild liquid detergent. Do not
use abrasive scouring pads or powders. Never
immerse the kettle in water or other liquids.
Since this kettle has concealed heating element,
is it important to keep the bottom clean, between
the decalcification you may use a washing-up
brush or sponge.
From time to time, dependent on the nature of
your water supply, a limescale deposit is naturally
formed and can be found mostly adhered to the
heating element and reduce the heating capacity.
The amount of limescale deposited (and
subsequently the need to clean or descale) largely
depends on the water hardness in your area and
the frequency with which the kettle is used.
14
1
2
3
4
5
7
6
245014 IM 25/02/03 11:09 Side 14