Filter
Top Products
10
11
INTRODUCTION
To get the best out of your new blender, please read
through these instructions carefully before using it for
the rst time. We also recommend that you keep the
instructions for future reference, so that you can remind
yourself of the functions of your blender.
SAFETY MEASURES
Normal use of the blender
• Incorrect use of the blender may cause personal
injury and damage to the blender.
• Use the blender for its intended purpose only. The
manufacturer is not responsible for any injury or
damage resulting from incorrect use or handling
(see also Guarantee Terms).
• The blender may only be connected to 230 V, 50 Hz.
• The base of the blender or cord must not be
submerged in water or any other liquid.
• Do not operate with wet or damp hands. Make sure
that no liquid gets into the base.
• Never leave the blender unattended when in use
and keep an eye on children.
• The blade must be handled with care, as it is
extremely sharp.
• NEVER insert your ngers, kitchen utensils or similar
into the blender jug while the blender is running or is
connected to the mains.
• Never remove the lid or ller cap from the blender
jug while the blender is running.
• Do not leave the blender running for more than 1
minute at a time. If it has been running for 1 minute,
you should leave it to cool down before using it
again.
• Never use the blender if the jug is empty.
• Not suitable for commercial or outdoor use.
• Take care that the lid does not come off during
operation, especially if the glass is full or if you
are blending hot liquids. To avoid the lid coming
off, place a tea towel over the lid and hold it tight
against the lid.
• This appliance is provided with a safety switch to
prevent starting the appliance unintentionally. Only
deactivate the safety switch, if the appliance is
completely and correctly assembled, and all parts
have been tted as described in the user guide.
Otherwise the appliance cannot be switched on! We
recommend you carefully check the assembly of the
appliance, if the appliance cannot be started.
Positioning the blender
• Always place the blender at the back of the kitchen
counter.
• Do not place the blender next to hot areas, for
example gas rings and electric hotplates.
• Do not allow the cord to hang over the edge of a
table/counter, and keep it away from hot objects
and naked ames.
Cord, plug and mains socket
• Ensure that the cord is fully extended.
• Check regularly that the cord and plug are not
damaged and do not use the blender if they are, or
if it has been dropped or damaged in any other way.
• If the blender, cord or plug is damaged, the blender
must be inspected and, if necessary, repaired by
an authorised repair engineer, otherwise there is a
risk of electric shock. Never try to repair the blender
yourself.
• Unplug the blender before replacing the blender
jug with the coffee/spice mill and vice versa, before
removing the lid from the jug or the mill, before
cleaning, and when the blender is not in use.
• Avoid pulling the cord when removing the plug from
the socket. Instead, hold the plug.
• Check that it is not possible to pull or trip over the
blender cord or any extension cord.
KEY TO THE BLENDER PARTS
1. Release button for jug lid
2. Filler cap
3. Jug lid
4. Blender jug
5. Blade
6. Blender shaft
7. Base
8. On/Off button
9. Coffee/spice mill (646-048)
10. Mill lid (646-048)
PRIOR TO FIRST USE
Place the base (7) on a at surface, e.g. a kitchen
counter, and make sure it is standing rmly on the four
suckers underneath.
Before using the blender for the rst time, or after
prolonged storage without use, wash any parts that will
come into contact with food.
UK