Filter
Top Products
14 15
14 15
ASSEMBLY AND PREPARATION
FOR USE
Position cord between base (3) halves.
Assemble base by slotting studs into
their corresponding holes. Check
cord can run freely through holes in
middle of base and that plug is passed
through base to underside (black
panels).
Mate base to underside of apparatus.
Screw into place using the four screws
supplied.
Press cord into recess on base for
protection.
Stand apparatus on base. The
apparatus now ready for use.
Clean apparatus before rst use.
USE
1. Plug in and switch the power on.
2. Turn apparatus if necessary so that
vent slats (2) point in the desired
direction.
3. Lift control panel cover (1).
4. Turn timer button (5) to "I (ON)",
and select fan speed on fan speed
buttons (6). The apparatus will
start.
5. The timer button can also be used
to set length of time apparatus
is to be switched on. Turn timer
clockwise to the time required.
The apparatus will start when fan
speed is selected.
6. If the rotation function (4) is
pressed, the apparatus will rotate
slowly from side to side, until the
apparatus is switched off or the
switch is released.
7. If the timer function is used,
the apparatus will switch off
automatically when the set time
has expired. If the timer function
is not used or the apparatus is
switched off before the set time
has expired, switch the apparatus
off by pressing the fan speed
button "0 (OFF)" and turn the timer
button to "O (OFF)".
Fan speed button Power
0 (OFF) None
(apparatus switched off)
1 Low
2 Medium
3 High