Connected to Hot water: Use the “ECONO” feature
The “ECONO” feature gives you the option of washing dishes
at the temperature of your hot water supply.
To activate, set the “SANI/ECONO” button to the “out”
position.
! IMPORTANT !
The “SANI/ ECONO” feature only influences “NORMAL”
wash.
When the “ECONO” feature is activated, drying time for
the dishes will be increased. The dishes dry by a
“convection” method only. To speed-up the drying time
after the program is complete, push the “Door Open”
button and the door pops open to a pre-set convection
dry position.
Operating Instructions
To operate the dishwasher:
1. Make sure the inlet and drain hoses are correctly and
securely connected.
2. Push the door release button to open the door.
3. Place the dishes on the dish rack and cutlery inside the
cutlery basket.
4. Check to make sure that the rotating spray arm can turn
freely all the way round. If necessary remove any
obstacles.
5. Fill the detergent in the recessed area on inner door
panel. (5-20 grams could be added according to the
quantity of dishwares and polluting conditions).
6. Close the door firmly
7. Open the water supply.
8. Turn the selector switch to the desired wash program.
(Normal, Rapid).
9. Push the power (on/off) button.
-Push Button in = power on
-Push Button out = power off
The power light will illuminate indicating the machine is
receiving power.
10. The dishwasher stops automatically at the end of the
programme. The power light will remain illuminated,
until the power (on/off) button is switched off.
11. The dishwasher is designed to stop if the door is
opened accidentally during operation.
12. After washing, dishes should be allowed to cool down
for about 15 minutes so they are not too hot to handle.
Dishes will cool quicker if the door is opened slightly.
13. After unloading the dishwasher, remove the filter, clean
off any bits of food, and put the filter back in its
position.
NOTE: At the beginning of each cycle, the dishwasher always
starts in the “drain” mode. This is because the drain pump
always retains a small amount of water (in the sump) from the
previous cycle. This is necessary to keep the pump primed.
Therefore, do not be alarmed if you see a small amount of
water being pumped-out from the drain hose prior to the start
of the regular wash cycle (THIS IS NORMAL).
Programme Summary/Selection (approximate figures)
NORMAL/SANI:
Water Temperature: 62°C
Programme Duration: 85 minutes
Water Consumption: 10 litres
NORMAL/ECONO:
Water Temperature: Incoming water supply
Programme Duration: 70 Minutes
Water Consumption: 10 litres
RAPID:
Water Temperature: Incoming water supply
Programme Duration: 15 minutes
Water Consumption: 6 litres
(Note: the washing time may vary according to the incoming
water temperature and the environmental temperature).
Main technical data
Model WP5BS
Power input 1380W
Outer dimension 570x480x500
Weight About 24,5kg
Max. water Consumption (Normal wash) 10L
Water pressure 0.03~1MPa
Control manner Mechanical
Detergent dosage 5~20 g
17
758007_IM_new 03/02/06 12:56 Side 17