Filter
Top Products
Brewing
1. Plug into 120V ~ 60 Hz outlet.
2. Make sure unit is in the OFF position. The Indicator Light will
be off.
IMPORTANT: Place coffee maker on a level surface.
3. Markings on the Water Level Indicator indicate the amount of
water required to brew the desired number of Thermal Mugs.
Lift up the hinged Water Chamber Lid and fill to desired level
with cold, fresh water for the number of Thermal Mugs (one or
two), using the Water Level Indicator on the Water Window.
WARNING: When making one Thermal Mug, do not fill above
level 1.
IMPORTANT: If cream or milk will be added to Thermal Mugs,
use less water for brewing.
4. For optimal holding temperature, rinse the inside of Thermal
Mugs with warm water before brewing. Place Lids securely on
tops of Thermal Mugs. Press down on the Lids to ensure
proper fit.
NOTE: You can brew either one Thermal Mug or two Thermal
Mugs at once. Place Thermal Mugs snugly on Base of unit as
shown in Figure A (for two Thermal Mugs) or Figure D (for one
Thermal Mug). The contoured design on the Base should be
used as a guide for Thermal Mug alignment.
5. Insert a #2 paper cone filter into the Removable Filter Basket
and add coffee grounds. Use approximately 1
1/2-2 tablespoons
for each Thermal Mug of coffee. Close Water Chamber Lid.
6. Press Power Switch ON. The Indicator Light will turn on.
CAUTION: Avoid contact with heated water.
IMPORTANT: Do not remove Thermal Mugs until the Indicator
Light has turned OFF. The Indicator Light will turn OFF
approximately two minutes after brewing is complete. This
delay will allow the last drops of coffee to flow into the Thermal
Mugs.
7. After Indicator Light turns off, Thermal Mugs may be safely
removed.
8. If brewing more than one cycle, allow unit to cool for 10
minutes between cycles.
7