Melitta MEK1 Hot Beverage Maker User Manual


 
2
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
a l w ays be fo l l owed to reduce the risk of fire, electric shock and injury
to persons, including the fo l l ow i n g :
Read all instructions before using ke t t l e.
Do not touch hot surfa c e s. Use handle.
This kettle is not for use by children.
Close supervision is necessary when any appliance is used near
c h i l d r e n .
Do not operate unattended.
Unplug from outlet when not in use. Unplug and allow to cool
b e fore cleaning and putting on or taking off part s .
To disconnect, raise lever to OFF position, then remove plug from
p o wer supply.
Do not operate a damaged ke t t l e. Do not operate with a damaged
cord or plug or after the kettle malfunctions, or has been dropped
or damaged in any manner. R e t u rn kettle to nearest authori ze d
s e rvice center for examination, repair or electrical or mechanical
a d j u s t m e n t .
Do not immerse cord, plug, power base or kettle in water or other
l i q u i d . See instructions for cleaning.
Use attachments only if recommended by the manu fa c t u r e r.
Do not use outdoors or while standing in a damp area.
Only use kettle as indicated in these instru c t i o n s .
Do not let cord hang over edge of table or counter or touch hot sur-
fa c e s.
Do not place on or near a hot gas or electric bu rn e r, or in a heated
ove n .
Be certain lid is securely in place before operating ke t t l e.
Scalding may occur if the lid is opened during boiling.
Do not operate without water in ke t t l e.
Kettle must be left to cool down for approximately 5 minutes befo r e
adding more wa t e r.
S AVE THESE INSTRU C T I O N S
C AU T I O N : A short power supply cord is provided to reduce the ri s k
of personal injury resulting from becoming entangled in or tri p p i n g
over a longer cord. Extension cords are ava i l a ble from local hardwa r e
stores and may be used if care is exercised in their use. If an ex t e n -
sion cord is required, special care and caution is necessary. Also the
cord must be: (1) marked with an electrical rating of 125V, and at least