Melitta MEVA10W Coffeemaker User Manual


 
CHARCOAL WATER FILTER
This unit features an optional charcoal water filter to provide optimum taste and
removal of most of the chlorine from tap water, along with other metals and
particles often found in tap water. To insert the charcoal filter, lift the lid of the
coffeemaker. Remove the new charcoal filter from the plastic bag and rinse
thoroughly under running water. Place charcoal filter in filter holder, making
sure charcoal filter drops down completely in water filter holder, (see figure 2).
Snap water filter holder handle on top of filter holder. Place charcoal filtration
system down into cutout on left side of water chamber. The water will be
filtered when poured in the water chamber. Filters should be replaced either
after 60 uses or 6 weeks (whichever occurs first) To order replacement water
filters call 1-800-947-3744 OR 1-800-947-3745 or e-mail us at
salton@saltonusa.com. Please reference part no. 30754. Do not attempt to
clean the filter.
Charcoal Filter
Each charcoal water filter comes with a set of monthly stickers. Write the day
next to the month; this will allow you to keep track of when you started using
the water filter.
If you use bottled drinking water or your water contains only a small amount of
chlorine, you may not notice a difference in the taste of your coffee when using
the filter.
BREWING
1. Plug into 120 V ~ 60 Hz outlet.
2. Lift up the hinged lid on top of the coffeemaker and slowly add cold water
to desired level using the water level indicator (between 2-10 cups).
3. Make sure that carafe with lid is properly seated on warming plate.
4. Fold the perforated edge over on a #4 cone-shaped paper filter, place
into removable filter liner and add coffee grounds. Use approximately
1 measuring spoon (1 level tablespoon) of grounds for every cup of
coffee. Close the lid.
5. Press the ON button; the red light will turn on.
6. If you wish to serve a cup of coffee before brew cycle is complete –
“Pause and Pour,” – simply remove carafe from warming plate. Dripping
will automatically cease. Return carafe to position on warming plate
within 30 seconds; dripping will resume.
Note: If the carafe is not returned to the warming plate within 30 seconds, the
coffee will overflow from the filter basket.
7. The warming plate will automatically cycle to maintain serving
temperature as long as unit is on.
8. Press the OFF button when carafe is empty or not in use. The red light will
turn off.
9. Unplug and allow to cool for 10 minutes between cycles.
IMPORTANT: If not allowed to cool before immediate repeated use, water
placed in water chamber may become overheated. A spray of steam could be
released from openings, creating a risk of burns.
4