Mellerware 2200W Hot Beverage Maker User Manual


 
Before Use
1. Read these instructions carefully with the illustrations before using the
appliance for the first time.
2. Before connecting the kettle, check that the voltage indicated on the appliance
(under of base) corresponds with the mains voltage in you home. If this is not
the case, contact your dealer and do not use the kettle.
3. The kettle will switch off automatically when the water boiled. You can switch
the kettle off before boiling by manually using the switch.
4. After the kettle switch of automatically (or has been switch off manually) it will
need some time to cool down. After 15-20 seconds, the kettle can be switched
on again.
5. The kettle is protected against damage, due to operation with insufficient water,
by means of a safety cutout. This cuts off the power when the heating element
gets too hot.
6. If the kettle runs dry while operating, allow to cool down for 15 minutes before
refilling with cold water. The safety cutout will automatically reset.
7. Place the appliance on a stable flat surface. Ensure that the kettle cannot fall
into water.
8. Never immerse the kettle in water. Do not allow water to penetrate the electrical
parts inside the kettle.
9. Prevent children from pulling the mains cord, or knocking the kettle over.
10. Before cleaning the kettle, make sure the kettle is disconnected from the power
supply and has fully cooled down.
11. The kettle may be cleaned with a damp cloth.
12. Pour away the very first water boiled from this kettle. The appliance is ready for
use.
13. Only use the base unit supplied with this product, if a replacement is required
only approved components must be used.
Operating Instructions
1. Make sure that the filter is pressed into the holes of the lid tongue and fitted
correctly.
2. Fill the water into the kettle,maker sure the water capacity is not lower than the
minium mark and does not exceed the maximun level.
3. Ensure the lid is closed fully.
4. Plug in.
5. Put the kettle body onto the base.
6. Switch the unit on,make sure the indicating light on.
7. When the water is boiled,the unit will automatically cut-off and the indicating
light will turn off.
8. If the water has to be reheated,please switch the unit on after several minutres
of cooling down.
22362a_IM.indd 4 2011/03/08 10:48:49 AM