Filter
Top Products
Anomalies and repair
- Take the appliance to an authorised technical
support service center if any problems arise.
Do not try to dismantle or repair without
assistance, as this may be dangerous.
- If the plug has been damaged, it must be
replaced and you should proceed as you
would in the case of damage.
edge of the mincing head (fig. 5).
- Insert the sausage accessory through the locking
rim (fig. 7).
- Screw the lock rim tightly onto the outlet mouth of
the mincing head, turning clockwise to secure the
endless screw, cutting blades and the cutting plate
(fig. 6).
- Position the tray at the top of the mincing head.
Kibbeh accessory (M)
- Press & hold the lock button while inserting
the mincing head (fig. 1). Then turn the mincing
head anti-clockwise until the chute is vertical.
Release the lock button to secure the mincing head
in position (fig. 2).
- Insert the endless screw through the outlet
mouth of the mincing head (fig. 3).
- Insert the Kibbeh accessory base onto the
endless screw and position the other Kibbeh
accessory on top. Fit the bulges of the Kibbeh
base in the notches of the filling mouth (fig. 8).
- Screw on the lock rim, turning clock-wise to
secure the Kibbeh accessory onto the endless
screw (fig. 9).
- Position the tray at the top of the mincing head.
Reverse Function:
- If food gets stuck, switch off the appliance.
Press the I/ II knob and set to “II” position and
ON/0/R switch to “R” position.
- The endless screw will rotate in the opposite
direction and unclog the mincing head.
- If this doesn’t work, switch off the unit and clean it.
Once you have finished using the appliance:
- Turn the appliance off, using the on/off switch.
- Remove the plug from the wall socket.
- Clean the appliance.
Cleaning
- Clean the equipment with a damp cloth and a few
drops of washing up liquid, and then dry.
- Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance, power cord or
plug in water or any other liquid or place under
running water.
- During the cleaning process, take special care
with the blades, as they are very sharp.
- The following components may be cleaned in a
dishwasher: tray, mincing head, lock rim, endless
screw and cutting plates.
This appliance complies with
Directive 2006/95/EC on Low Voltage
and Directive 2004/108/EC on
Electromagnetic Compatibility.
26602 IM.indd 5 24/08/2011 09:05:23