Filter
Top Products
IMPORTANT
1. Please read the instructions for use carefully in
conjunction with the illustrations before using
the appliance.
2. Check if the voltage indicated on the appliance
corresponds to the mains voltage in your
home.
3. The coffee mill cannot be switched on until the
cover has been placed in position.
4. Do not take off the cover before the blades
have come to a complete standstill.
5. Clean the mill beaker regularly. But ensure
never to immerse the appliance in water or
other liquids. Do not rinse either. You can clean
the appliance with a damp cloth after removing
the plug from the mains socket.
6. Do not operate the coffee mill for longer than
1 minute continuously as this could cause
overheating. Let the motor cool down (for
10-15 mins) after long operation before you
continue.
7. Switch off the appliance before changing
accessories or approaching parts which move
in use;
8. Do not fill water and any other liquid into the
mill beaker.
9. If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order to
avoid a hazard.
10. This appliance is not intended for use by
children or other persons without assistance or
supervision if their physical, sensory or mental
capabilities prevent them from using it safely.
Children should be supervised to ensure that
they do not play with the appliance.
HOW TO OPERATE
1. Fill the mill beaker (fig. 2)
Do not fill higher than two or three millimeters
below the rim. You may use the cover for this
purpose.
A maximum filling results in a quantity of ground
coffee which is enough for about 10 cups.
2. Place the cover (fig. 3)
3. Insert the main plug into a wall socket.
4. Holding the coffee mill with both hands, press
and hold switch (B) (fig. 4)
With a maximum filling the operation takes
about 30 seconds. The longer you continue
the operation, the finer the results will be.
(Note: do not over-process!)
5. Release switch (B)
6. Remove the main plug from the wall-socket.
7. Tap the cover to remove ground coffee sticking
to it (fig. 5). Then open the coffee mill (fig. 6).
CORD STORAGE
You can store excess main cord by winding
around the bottom of the main unit. (Fig. 7).
MW_EX29105 Aromatic_IM.indd 3MW_EX29105 Aromatic_IM.indd 3 11/5/2008 2:38:05 PM11/5/2008 2:38:05 PM