Filter
Top Products
the appliance to timer standby mode (green LED
will be on). Pressing the “auto” button again will
switch off the standby mode. Resume the standby
mode again by pressing the “auto” button. Press
the “pro” button to check the timer pre-set time.
Press the “pro” button again to confirm and
the display will go back to the present time.
Pressing “on/off” at any time will switch on
the appliance and red LED will be on. The
appliance will start functioning at the pre-set
time (red LED will be on). The appliance will turn
off automatically after 2 hours and the LCD will
show the present time. Adjustable time range :
23 hours 59 minutes.
2.4 “Hr” hour button: this button only functions while
setting the time and timer. Press this button for
every hour increasing. Holding this button will
make the hour setting run quickly.
2.5 “Min” minute button: same as “hr” setting.
To make coffee
1. Open up the lid of the coffee maker and fill the
fresh water container with as much water as cups
of coffee are desired.
2. Ensure that the water level does not exceed the
max level mark inside the water tank.
3. Close the lid of the coffee maker.
4. The water level display in the glass jug indicates
the number of cups.
5. Put ground coffee as you need into the
permanent filter or proper paper filter before
making coffee. (Take 6-7 g medium fine ground
coffee per cup).
6. Close the lid.
7. Ensure that the glass jug is placed properly in its
position.
8. Switch on the appliance and the pilot lamp
illuminates, to indicate the unit is on.
9. After the brewing process, the heating element
will keep the coffee warm for 2 hours, after
which the appliance will switch off to prevent
overheating.
10. If the glass jug is empty, do not leave the
appliance on, as the heating element may crack
the glass jug.
Cleaning and maintenance
1. Disconnect the appliance.
2. Never immerse the appliance in water.
3. Clean the appliance with a damp cloth only.
4. The glass jug and permanent filter can be cleaned
with warm water, some washing-up liquid and
a soft brush. Do not clean the glass jug in a
dishwasher.
De-scaling
To ensure a long lifespan of the coffee maker, you will
need to de-scale it from time to time. Frequency will
depend on how hard the water is in your area, and how
often you use the coffee maker. If you use your coffee
maker once or twice a day, the following guidelines for
de-scaling should be used:
• Soft water, every 6 months.
• Medium water, every 2-3 months.
• Hard water, every 6-8 weeks.
If the time it takes to brew a cup of coffee is suddenly
increased, it is recommended that the coffee maker
be de-scaled. The harder the water is in your area, the
more often the coffee maker needs to be de-scaled.
The hardness of the water can be advised at your local
waterworks.
Environmental tip
An electronic appliance should, when it is no longer
capable of functioning be disposed with least possible
environmental damage. The appliance should be
disposed according to the local regulations of your
municipality. In most cases you can discharge the
appliance at your local recycling center.
Caution
• The supply voltage from the wall socket must
correspond with the voltage stated on the rating
label at the bottom of the appliance.
• Use only cold water to fill the water tank!
• Ensure the glass jug is placed properly in its
position when brewing coffee.
• Between the brewing processes switch off the
appliance and let it cool down for about 5
minutes. Then refill with cold water.
• After the brewing process, always switch off the
appliance.
• Disconnect the appliance before cleaning.
• Keep the appliance out of reach of children.
• To switch off the appliance use the on/off switch.
• The control lamp going out indicates when the
machine is off.
Other
• The appliance must only be used for purposes as
laid out by this instruction manual.
• The supplier will not be held liable for damages
caused by improper use of the appliance.
• Only an authorized repair agent may carry out
repairs on this appliance. Any attempts to repair
the appliance without using an authorized repair
agent will negate the guarantee.
• In order to locate the authorized repair agent in
your area, please consult the supplier.