Filter
Top Products
Hot Food Merchandisers Ops Manual
2
BEFORE INSTALLATION
NOTE: Upon receipt of this unit, immediately unpack and inspect for possible concealed shipping damage. If unit is found to be damaged, save
all packing materials and contact your delivery carrier within 5 days. Refer to “Shipping Damage Instructions” enclosed for detailed instructions.
Failure to follow these instructions will negate Merco Savory’s or your ability to file claims and receive compensation for shipping damage.
This manual contains important safety and installation-operation instructions. Require all operators to read this manual before using the unit.
Failure to follow the instructions contained in this manual may cause injury, damage to the unit, and will void the warranty.
INSTALLATION
1. Check the specification data plate located on the bottom for model number, voltage and wattage.
2. Insure the electrical circuit used to supply electricity to the unit has the same voltage rating as indicated on the data plate and sufficient
amperage rating.
3. Plug cordset into outlet.
OPERATION
1. Make sure unit is plugged into appropriate outlet.
2. Turn on infinite temperature control knob to desired setting, pilot lights will illuminate indicating top and bottom heat is on and allow to heat
for about 30 minutes. The pilot light will cycle on and off as it heats.
3. Place hot, cooked food into unit.
IMPORTANT: Do not allow food to cool before placing in unit.
NOTE: Food that has been heated once and then cooled has lost most of its moisture while sitting in the open air. It cannot be reheated with
satisfactory results.
CLEANING
EXTERIOR OF UNIT
1. The stainless steel exterior of your unit may be cleaned with a soft, damp, soapy cloth or sponge. Be careful not to scratch the surface.
2. Rinse with clean, damp, soft cloth or sponge.
3. The glass may be cleaned with Windex or a multi-surface cleaner.
Alternate Method: Clean the exterior using a stainless steel cleaner/polish, taking care to follow the manufacturer instructions. For best
results, always polish following the grain direction of the metals finish.
4. CAUTION: Be careful not to allow water to run into electrical compartments as electrical shock or damage could result.
5. The interior surfaces of this unit needs nothing more than a daily wiping with a soft, damp cloth.
6. Do not use abrasive cleaners on any part of this unit. This will cause damage to the finish of the unit.
WARNING:
!
Be sure to disconnect from power source prior to cleaning of unit.