Filter
Top Products
13
EN
12
EN
7/ LOADING OF RINSING PRODUCT
Important :
Only use a rinsing product designed for
dishwashers. The rinsing product ensures
your items shine and are well dried.
When first putting the machine into
service, fill the tank until the level is flush with
the top of the adjustment lever. Pour in at least
all the rinsing product provided.
The tank contains 120 ml (approximately one
glass)
The original setting is in the centre (middle
position: reference mark 2). If you encounter
marks or poor drying after a few cycles, you
can adjust the setting using the adjustment
lever
(fig 07
;
Reference mark 3 will
increase the setting).
- Close the tank lightly
••
Rinsing liquid indicator light:
This illuminates when rinsing product is
required.
It can be deactivated as shown in the para-
graph “For multi-purpose products” setting
table.
Important :
If any of the product overflows during
filling, sponge up the excess to avoid pro-
ducing foam.
CC
BBAA
• Loading of rinsing product (Fig. 07)
Adjustment lever
Fig. 07
1
2
3
1
2
3
AA
BB
CC
6/ LOADING OF REGENERATING SALT
• Loading of regenerating salt (Fig 06)
Filling with salt is essential for providing a
good wash without marks. It regenerates the
resins that soften the water, by removing its
lime content (unless the mains water supply is
soft enough). Refer to “Setting the water sof-
tener”.
Important :
Only use special dishwasher regener-
ating salt. Do not use table salt or any type of
cooking salt, this could damage your appli-
ance’s water softener.
Unscrew and remove the stopper on the
salt tank.
Fill the tank with regenerating salt special-
ly designed for dishwashers.
Use the funnel supplied with your dish-
washer. The first time, top up with water up to
the rim of the tank.
• Regenerating salt indicator:
This illuminates when salt must be added.
After the tank has been filled with regenerat-
ing salt, the indicator light may remain lit until
the salt has dissolved sufficiently, usually
after one cycle (of if the tank has not been
filled completely; for example, when first put-
ting the machine into service using the sam-
ple).
This can be deactivated as indicated in the
paragraph “For multi-purpose products” set-
ting table.
Important
If the salt overflows when filling the tank,
to avoid oxidization of the tub it is advisable to
remove the salt crystals or to run a Prewash
programme (or Rapid programme -
depending on the model).
CC
BB
AA
EAU
SEL
Fig. 06
AA
BB
CC
SSaalltt
wwaatteerr