Filter
Top Products
Adhering the insulation strips
^
Remove the protective foil from the
adhesive strips.
^ Align the metal strips flush against
the side and rear walls of the cabinet
a and stick them on to the plate
warmer b (see illustration).
The third metal strip is not needed if the
cabinetry does not have a rear panel.
^
Install the combination appliance in
accordance with its own specific op
-
erating/installation instructions and
then connect the electrical supplies.
Aligning the front of the plate warmer
After installing the combination appli
-
ance, it may be necessary under cer
-
tain circumstances to
–
align the front of the plate warmer.
–
align the gap between the plate
warmer and the combination appli
-
ance.
To help you do this, there are adjusting
points underneath the nuts which se
-
cure the drawer to the telescopic run
-
ners.
^
Loosen the nuts and take the plate
warmer drawer out.
Use the adjusters to align the drawer
correctly.
Installing the plate warmer
17