Filter
Top Products
Optimize standby
A few minutes after the last key is
pressed or at the end of the program
the dishwasher will switch into Standby
mode to save energy.
This function can also be turned off.
The dishwasher will then turn off
completely after 6 hours.
^
Select the desired setting and
confirm with
OK.
If the Standby option is turned on,
the clock will only be displayed for a
few minutes.
If refill salt and/or rinse aid or an fault
are present in the display, the
dishwasher will not turn off.
The refill messages can be turned
off when you use a tab detergent
(see "Settings-Refill display").
Fault messages cannot be turned
off.
Refill display
When consistently using multi-function
Tab detergents, you can turn off the
refill displays.
^
Select the desired setting and
confirm with
OK.
Be sure to turn this setting back on if
you stop using multi-function tab
detergents.
Check filters
This selection allows you to set the
number of programs run before the
filter check message shows.
You can select between 30 and 60
programs.
The filter check message is set by
default to 50 programs.
^ Select the desired number of
programs and confirm with
OK.
Settings !
52