Filter
Top Products
Issue Possible fault Solution
Glasses are
discolored and the
film cannot be wiped
off.
Detergent deposits. Use a different detergent.
Clouding or etching
on glasses.
Possible causes may be :
excessive rinse aid or type
and amount of detergent.
Any one or a combination
of these faults may be to
blame.
See the relevant section of
this manual to:
– adjust the rinse aid
dosage,
– change the type and/or
adjust the amount of
detergent used,
– connect the dishwasher
to a cold water supply.
Glasses are dull and
discolored, film
cannot be wiped off.
Glasses are not
dishwasher safe.
There is no remedy. Only
wash dishwasher safe
glasses in the dishwasher.
Tea or lipstick stains
have not been
completely removed.
The wash temperature of
the selected program was
too low.
Select the ""SaniWash"
program.
The detergent has a low
bleaching effect.
Use a different detergent.
Plastics are
discolored.
Natural dyes e.g. from
vegetables may be the
cause. Not enough
detergent was used to
break down natural dyes.
Use more detergent, see
"Adding detergent".
Discoloration is permanent.
There are rust stains
on cutlery.
The affected items are not
corrosion resistant.
There is no remedy. Only
wash dishwasher safe
cutlery in the dishwasher.
No program was run after
refilling salt. Salt residuals
got in the wash cycle.
Start the "Express" program
without a load after refilling
salt.
The salt container lid was
not screwed on properly.
Reseat and screw the lid
on firmly.
Frequently asked questions
36