Filter
Top Products
Buzzer
A signal sounds at the end of a
program and when a fault occurs.
The buzzer at the end of a program
sounds five times in quick succession
for up to one hour.
The buzzer for a fault sounds
continuously for up to two minutes.
The buzzer is activated by default. It
can be turned off, so it does not sound
at the end of a program. The buzzer for
a fault cannot be turned off.
^ Open the door.
^ Turn the dishwasher off with "o".
^ Press the "Program" button and at the
same time turn the dishwasher on
with "g".
^ Hold the program button until the
"Rinse & Hold" program indicator
comes on.
If it does not come on, start over.
^ Press the "Program" button four
times.
The "Intake / Drain" indicator flashes
four times in intervals.
The setting can be recognized by the
flashing of the "SaniWash" indicator:
– flashing: buzzer is activated
– not lit up: buzzer is deactivated
^ To change the setting press the
"Program" button for at least one
second, until the "Intake / Drain"
indicator lights up.
^ Press the "Program" button.
The setting is saved.
^ Turn the dishwasher off "o".
Additional options
30