Filter
Top Products
"3 in 1" tabs
The function "3 in 1" adjusts the
program cycle to the use of "3 in 1"
detergent products (detergent with
rinse aid and water softener salt). The
rinse aid dosage and rinse aid refill
messages are deactivated. The salt
usage for the water softener will be
reduced to
1
/
3
-
1
/
4
of the normal
amount.
Do not use this extra feature :
–
when using "2 in 1" detergents
(detergent with rinse aid)
– if your tab water has a water
hardness of over 21°.
See also the information from the
detergent manufacturer.
The cleaning and drying
performance of these detergent
products vary.
The detergent selection is set by
default to powder detergent.
^
Select the desired detergent and
confirm with OK.
Water hardness
The dishwasher is equipped with a
sensor softener, which automatically
detects the hardness of your tap water.
After plumbing the dishwasher and
finishing a program, e.g. "Rinse +
Hold", the water hardness is displayed
in the menu "Water hardness".
^
Press OK to go back to the
"Settings J" menu.
External water softener
If the dishwasher is connected to an
external water softener unit which is
regenerated with salt, the water
hardness must still be set in the
dishwasher. Set the dishwasher to the
water hardness of your water softener
unit.
If you don't know the value, set the
dishwasher water hardness to 8°d
(8 gr/gal [US]).
^ Set the dishwasher to the water
hardness of the external water
softener and confirm with
OK.
If the dishwasher is not longer
connected to an external water
softener, set the setting to
Auto.
Settings J
41