Filter
Top Products
Optimize Standby
A few minutes after a button has been
pressed or the end of a program, the
dishwasher changes to Standby mode
to save energy. The indicator lights and
time display will go out, and only the
Start/Stop indicator will flash slowly.
The dishwasher will not switch to
Standby mode while a program is
running.
If the dishwasher is not turned off at the
end of the program and the door is not
opened, it will turn off completely after a
few minutes in Standby mode.
The Optimize standby function can be
deactivated if desired. The display and
the indicator lights will not go out, and
the time lapse before the dishwasher
turns off will increase to approx. 6
hours, resulting in higher energy
consumption.
^
Press the K button to turn the
dishwasher off.
^
Press and hold the "Start/Stop" button
and turn the dishwasher on
simultaneously using the K button.
Keep the Start/Stop button pressed
for at least four seconds until the
"Start/Stop" indicator light comes on.
If it does not come on, start over.
^
Press the Delay start button eight
times.
The "Delay Start" indicator will flash
briefly 8 times in intervals.
The flashing sequence in the display
shows what the current setting is.
–"P1": The "Optimize standby" function
is activated.
–"P0": The "Optimize standby"
function is deactivated.
^ Press the "Start/Stop" button if you
wish to change the setting.
The setting is saved immediately.
^
Press the K button to turn the
dishwasher off.
Additional options
40