Filter
Top Products
Programming the water
softener
To exit the programming mode at
any time turn the dishwasher off with
the K button.
^ Press the K button to turn the
dishwasher off.
^ Press and hold the "Start / Stop"
button and turn the dishwasher on
simultaneously using the K button.
Keep the "Start / Stop" button
pressed for at least four seconds until
the "Start / Stop" indicator light comes
on.
If it does not come on, start over.
^ Now press the "Delay Start" button
twice.
The characters "P15" will flash one
after the other in the display. This
means that the water hardness level
has been set at 15 °d [16 gr/gal (factory
setting)].
The value which has been set for the
water hardness is shown as a figure
after the "P" in the display (see chart).
^ Use the "Start / Stop" button to select
the flashing rhythm that corresponds
to your water hardness level.
With each press of the button the
value will raise one level. Once the
highest value is reached the setting
will start again from the beginning.
^ Press the K button to turn the
dishwasher off.
°d gr/gal
Value
displayed
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37-50
51-60
61-70
1
2
3
4
5
6
7
8
9
10
11
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
38
39-52
53-63
64-73
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
50
60
70
Before using for the first time
12