Filter
Top Products
Time display
Before the program starts, the time
display shows the runtime of the
selected program in hours and minutes.
The remaining time is displayed during
the program.
The time that is displayed may vary for
the same program. It depends on the
temperature of the incoming water, the
reactivation cycle, the type of detergent
and the quantity and soiling of the
dishes.
When a program is selected for the first
time, the display shows an average
program time for cold water.
With every program, the electronics
correct the time according to the
temperature of the incoming water and
the size of the load.
Standby
A few minutes after the last button is
pressed or a few minutes after the end
of the program the dishwasher will
switch to Standby mode to save
energy. The time display and the
indicator lights are turned off and only
the K indicator light flashes slowly.
^
Press the K button if you want to turn
the indicator lights back on.
If the dishwasher is not turned off after
the program ends, after a few minutes
in standby mode it will turn off
completely (see "Additional options -
Optimize Standby").
If Salt and/or Rinse aid or a fault is
displayed, the dishwasher will not
switch to Standby mode.
If you use a Tab detergent, you can
deactivate the refill messages and
let the dishwasher go into Standby
mode (see "Before using for the first
time").
However, fault messages cannot be
turned off.
Use
34