Filter
Top Products
Contrast
There are seven different display
contrast settings.
^
Select the desired contrast and
confirm with the center button.
Filter check
This selection allows you to set the
number of cycles run before the filter
check message shows.
You can select between 30 and 60
cycles.
The "Filter check" message is set by
default to 50 cycles.
^ Select the desired interval and
confirm with the center button.
Showroom program
Only for showrooms.
The dishwasher has a demo program
for dealer's showrooms.
–
Demo with wash sound:
The program activates the pumps to
demonstrate the wash sound.
Turning the demo mode on
^
Select the desired option.
^
Select the option
On and confirm with
the center button.
^
Close the Settings menu.
^
Press the Start / Stop button.
Demo mode will begin.
Turning the demo mode off
Demo mode will turn off automatically
when it reaches the end of the cycle.
Factory default
If you have altered any settings from
the factory default, you can reset them
to the factory default settings.
^ Select
Reset and confirm with the
center button.
Leaving the Settings menu
Use Close to leave the Settings menu.
^
Select
Close and confirm with the
center button.
The display will then show the last
program selected and the indicator
light for the program selected will come
on.
Settings menu
44