Filter
Top Products
Time display
Before the program starts, the time
display shows the running time of the
selected program in hours and minutes.
During the running program the
remaining time is shown in the time
display.
Symbols will appear to indicate which
stage the program is at:
1 Pre-wash / Soak
8 Main wash
% Interim rinse
( Final rinse
G Drying
O Finished
The time displayed may vary with the
same program. This can be due,
among other factors, to the water
temperature at each intake, the
reactivation process, the type of
detergent, the number of dishes and
how soiled they are.
When a program is selected for the first
time, the display shows an average
time for a cold water intake.
Each time a program is run, the
electronic unit adjusts the program
running time according to the intake
water temperature and the load size.
Standby
A few minutes after the last key is
pressed or at the end of the program
the dishwasher will switch into Standby
mode to save energy. The display and
the indicators are turned off and only
the Start/Stop K flashes slowly.
^
To turn the dishwasher back on press
K.
If you do not turn the dishwasher off
after the program ends, it will turn
completely off after a few minutes in
standby mode (see "Settings - Optimize
standby").
If refill salt and/or rinse aid or a fault
are present in the display, the
dishwasher will switch into Standby
mode.
The refill messages can be turned
off when you use a tab detergent
(see "Before using for the first time").
Fault messages cannot be turned
off.
Use
35