Filter
Top Products
Programming the water hardness
level
^ Switch the dishwasher off using the
"On/Off" button (13).
^ Press the "Start/Stop" button (17) in
and whilst holding it in
switch the
dishwasher on using the "On/Off" but-
ton (13).
Release the "Start/Stop" button within
two seconds.
The "Wash/Rinse" indicator light (16)
and the fifth programme indicator light *
(14) (factory setting) will come on and
the Salt indicator light (15) will flash.
If this is not the case the process must
be repeated.
* The programme settings on the control panel
run from top to bottom.
Setting the machine for water hard
-
ness level 0.2 - 4.0 mmol/l (1°d - 22°d):
Use the programme buttons (19) to se-
lect the programme that corresponds to
your water hardness level (see Table 1).
The indicator light (14) next to the se-
lected programme flashes and the
"Wash/Rinse" indicator light (16) comes
on.
Table 1:
°d
(German
scale)
mmol/l Programme
position
1 - 4 0.2 - 0.7 1
5 - 7 0.9 - 1.3 2
8 - 10 1.4 - 1.8 3
11 - 13 2.0 - 2.3 4
14 - 16 2.5 - 2.9 5
17 - 22 3.1 - 4.0 6
^
Press the "Start/Stop" button (17) twice.
The programmed water hardness level
is now stored in memory.
^
Switch the dishwasher off using the
"On/Off" button (13).
Before using for the first time
14