Filter
Top Products
Before using for the first time
The stainless steel trim to the interior
shelves and the door shelves has a
layer of protective foil to prevent
damage during transportation.
^
Clean the inside of the appliance and
the accessories with luke warm water
and a little washing-up liquid, and
then dry with a soft cloth.
^
Carefully remove the protective foil
from the stainless steel trim.
Important:
To ensure the correct functioning of
the appliance, let it stand for
between 1½ and 2 hours after
transporting it to its final location
before connecting it to the mains.
Switching on
^
Using a coin, turn the On/Off dial in a
clockwise direction away from the "0"
position. The in-operation indicator
light comes on.
The higher the setting, the lower the
temperature in the appliance.
Forcing the dial beyond its range will
damage it. Turn it only as far as it
will go, then turn it back again.
The interior lighting will come on when
the door is open, and the appliance will
begin to cool down.
To enable the temperature to get
sufficiently cold inside the appliance,
allow the appliance to run for a few
hours before placing food in it.
Switching off
^
Using a coin, turn the On/Off dial in
an anti-clockwise direction back to
the "0" position.
The in-operation indicator light will go
out.
The cooling and the interior lighting are
switched off.
Switching off for longer
periods of time
If the appliance is not going to be used
for a longer period of time, e.g. whilst
on holiday:
^
switch the appliance off,
^
switch off at the wall socket and
withdraw the plug,
^
defrost the freezer compartment
(depending on model),
^
clean the appliance out and
^
leave the door ajar to air the
appliance.
If, during a long absence, the
appliance is switched off but not
cleaned out and the door is left shut,
there is a danger of mould and
odours building up inside the
appliance.
Switching on and off
13