Filter
Top Products
Before building the appliance in, you
will need to decide on which side the
doors are to be hinged. If left hand door
hinging is required, follow the
instructions below.
To change the door hinging, you will
need various sizes of Torx
screwdrivers and a slotted
screwdriver.
^
Open both appliance doors.
^
Pull off covers a, b and c and caps
d.
^
Unscrew hinge pin e from the top
appliance door.
^
Tilt the top door, and lift it up and off.
^
Then remove hinge pin f from the
middle of the appliance.
Take care when doing so that the
bottom door does not drop forwards.
^
Then lift the bottom door upwards
and off.
^
Unscrew upper hinge plate g, and
replace it on the opposite side using
the same screws.
^
Unscrew the middle hinge plate h,
and replace it turned through 180° on
the opposite side using the same
screws.
^
Remove lower hinge pin i together
with washer j, and replace these on
the opposite side.
^ Replace the bottom door on lower
hinge pin i. Remember to use
washer j.
^ Refit middle hinge pin f in hinge
plate h, and then tighten the screws.
^ Refit the top door on middle hinge
pin f.
^
Insert upper hinge pin e into the
outer hole in hinge plate g, and
tighten the screws.
^
Replace covers a, b and c on the
opposite side, turning them by 180 °.
^
Refit cover caps d on the opposite
side.
Changing the door hinging
40