Before you begin
Read these instructions completely
and carefully.
Have the appliance installed by a
qualified technician, according to
the enclosed installation instructions.
To reduce the risk of injury or
damage to the product, two people
should be used for installation.
These installation instructions are
intended for use by qualified installers.
In addition to these instructions, the
appliance must be installed in
accordance with all local codes. In the
absence of a local code, the following
should be used:
– In the USA, the National Electric
Code, ANSI/NFPA 70 - latest
edition/State and Municipal codes
and/or local codes.
–
In Canada, the Canadian Electric
code C22.1 - latest edition/Provincial
and Municipal codes and/or local
codes.
Tools needed for installation
–
Cutter with adjustable blade
–
Cordless screwdriver T 20
–
Torx screwdriver T 20
–
Hammer drill for drilling holes in wall
or floor
–
Wood drills in different sizes
–
Hammer
–
Open-ended wrench ½" (SW 13 mm)
–
Box-end wrench
–
5
/
16
" (8 mm) hex nut driver
– Adhesive tape
– Multi-grip pliers
– Level
– Metal tape measure
– Square
Other
–
Stepladder
–
Dolly, hand truck
–
Wooden beam
(cross section min. 29 ½" x 39
3
/
8
"
[75 cm x 100 cm] as an alternative tilt
protection, length depends on the
width of the installation cavity)
–
Wood screws in different sizes
Optional Tool
–
"Merging Kit" for side-by-side
installation.
Installing the appliance
57