Filter
Top Products
Before using for the first time
The stainless steel surface has a pro
-
tective cover to prevent scratching dur
-
ing transportation.
^
Do not remove this cover until the ap
-
pliance has been installed or built in.
Start at one of the upper corners.
^
Clean the inside of the appliance and
the accessories with luke warm water
and a little washing up liquid and
then dry using a soft cloth.
Important: To ensure correct func
-
tioning of the appliance, let it stand
for between ½ and 1 hour after
transporting it to its final location be-
fore connecting it to the mains.
Switching on
The refrigerator section and the freezer
section are switched on independently
of one another so that if required you
can switch on only one section.
Refrigerator section
^
Press the "On/Off" button for the re
-
frigerator section.
Bars appear in the temperature display
for the refrigerator section. The refriger
-
ator section starts cooling. The interior
light will come on if the door is
opened.
Freezer section
^
Press the "On/Off" button for the
freezer section.
Bars appear in the temperature display
for the freezer section and the alarm
sounds. The freezer section starts cool
-
ing.
Allow the freezer to run for a few hours
before placing food in it. This will en-
sure that the temperature in the freezer
is sufficiently low.
Switching off the alarm
^
Press the alarm button.
The alarm stops. The bars will continue
to flash in the temperature display until
the temperature range set has been
reached.
Ice pack
Place the ice pack in the top drawer or
to save space on the freezer tray. The
ice pack will be at its most effective af
-
ter it has been in the freezer for
approx. 24 hours.
Operation
11