Miele KM5753 Cooktop User Manual


 
The cooktop is fitted with a timer which
can be used to time kitchen activities
and/or to switch off the burners
automatically.
You can set a time from 1 minute (01)to
9 ½ hours (9.^). If the time is more than
99 minutes (99), the setting will be
shown in half-hour increments, which
appear after the decimal point.
Use the - and + touch controls to raise
and lower the time. There are pre-set
stops at 2 hours and at 99 minutes. To
override a stop, briefly remove your
finger from the touch control, then
touch it again to continue.
To re-set the display to 00,
simultaneously touch - and +.
When the set time has elapsed, 00 will
appear in the timer display for a few
seconds. At the same time an audible
signal will sound for a few seconds. To
turn the signal off before this, touch the
m sensor.
Setting the timer
The timer can be used with the cooktop
turned on or off. It works like a manual
kitchen timer.
^
Touch the m, - or + sensor.
Two dashes appear in the display, and
the timer indicator will flash.
^
While the indicator is flashing, touch
the - or + sensor until the desired
time appears in the display,
e.g. 15 minutes.
The time then counts down in minutes.
The time remaining can be seen in the
display and changed at any time by
touching - or +.
Timer
24