Miele KM5943 Cooktop User Manual


 
Sensor switches
This hob is equipped with electronic
sensor switches which react to finger
contact.
To operate a cooking zone, touch the
relevant sensor. Each time you touch a
sensor switch, an audible tone sounds.
Take care only to touch the middle
of the sensor required. Keep the
control panel clean, and do not
place anything on top of it. The
sensors may fail to react or they
could mistake the article or any dirt
for a fingertip contact, thereby
activating a function or even causing
the hob to switch off automatically
(see Safety switch-off.)
Never place hot pans on the sensor
switches. The electronic unit
underneath could get damaged.
Switching on
The hob must be switched on before
any of the zones can be used.
Do not leave the appliance
unattended whilst it is being used.
To switch the hob on
^
Touch the ON/OFF sensor s.
0 appears in each of the cooking zone
displays. If no further entry is made, the
hob will switch itself off after a few
seconds for safety reasons.
To switch a cooking zone on
^ Select a power setting between 1 and
9 or the keeping warm function by
touching the - or + sensor.
To select cooking with Auto heat-up,
press the - sensor first (see "Auto
heat-up"). To select cooking without
Auto heat-up, press the + sensor first.
If you wish to switch on another
cooking zone, and the 0 for that zone
has already gone out, simply press the
- or + briefly. The 0 will reappear and
you can select a power setting (with or
without Auto heat-up).
Use
31