Filter
Top Products
Problem Possible cause Remedy
The sensors are
over-sensitive or do
not react at all.
The sensitivity level of the
sensors has changed.
Make sure that there is no
direct light (from the sun or
from an artificial source)
falling onto the hob and that
the surrounding area is not
too dark.
Make sure that there is
nothing covering the sensors
or the hob. Take any pans off
the hob and wipe away any
food deposits.
Interrupt the power supply to
the hob for approx. 1 minute.
If this does not solve the
problem, please call the
Miele Service department.
An F lights up in the
rear left cooking zone
display and an E lights
up in the rear right
cooking zone display
and numbers appear
in the displays at the
front.
left right
90
A calibration fault has
occurred after the reset
function has been
activated or after an
interruption to the power
supply. If the displays do
not go out after 5 minutes,
proceed as described
under "Remedy" on the
right.
91
92
93
37The overheating
protection mechanism has
triggered.
You can use the hob again
as soon as the fault code
goes out (see "Overheating
protection").
44
47The fan is either blocked
or faulty.
Make sure it has not been
blocked by something like a
fork. Remove the cause of
the blockage. If the fault
message appears again, call
the Miele Service
Department.
48
All other fault codes
There is an electronic
fault.
Interrupt the power supply to
the hob for approx. 1 minute.
If the problem persists after
reconnecting the appliance
to the power supply, please
contact the Miele Service
department.
Problem solving guide
50