Miele KM 2030 Cooktop User Manual


 
Burners
Do not clean any parts of the burner
in a dishwasher.
The burner should be dismantled and
then cleaned by hand using a solution
of warm water and a little washing-up
liquid applied with a soft sponge.
Parts of the burner that cannot be
removed should be wiped clean with a
damp cloth only.
The ignitor and ignition safety device
should be very carefully wiped clean
using a well wrung out cloth.
Do not let the ignitor get wet. If it gets
wet it will not spark.
After cleaning, dry all surfaces with a
clean cloth.
Make sure that the flame slits are clean
and completely dry.
The surfaces of the burner caps will
become more matt with time. This is
quite normal and will not affect the
operation of the hob.
To assemble the small, medium and
large burners
^ Place the burner head c onto the
burner base d so that the the ignition
safety device e the ignitor f and the
retaining pins g fit into their
respective holes in the burner head.
^ Position the burner cap b onto the
burner head c so that the retaining
pins fit into their respective recesses.
Gently twist the burner cap clockwise
or anticlockwise until it locks into
position.
When correctly positioned it will not
slide about.
Important: replace parts in the correct
order after cleaning.
Cleaning and care
28