Filter
Top Products
^
Make the worktop cut-out according
to the dimensions given in the
building-in dimension diagram.
Remember to maintain the minimum
safety distances (see "Safety
instructions for installation").
^
Seal the cut surfaces on
wood/laminated worktops with a
suitable heat-resistant sealant to
avoid swelling caused by moisture.
Make sure that the sealant does not
come into contact with the top of the
worktop.
^ Feed the connection cable down
through the cut-out.
^ Place the hob in the cut-out without
securing it.
If the corners of the frame are not
flush with the worktop surface, the
corner radius (ß R4) can be carefully
scribed to fit.
^
Connect the hob to the mains (see
"Electrical connection").
^
Connect the appliance to the gas
supply (see "Gas connection").
^
Secure the appliance using the
brackets supplied a.
After installation
Check that all the burners are operating
correctly.
The flame must not go out on the lowest
setting, or when the control is turned
quickly from a high to a low setting.
On the highest setting, the flame must
have a distinctive and visible core.
Installation
44