Filter
Top Products
You can change the default settings of programme options
(see chart). Several settings can be altered in succession.
After programming mode has been called up, P (Programme)
and S (Status) will appear in the timer display. On hobs with 3
cooking zones, an additional indicator will appear at the rear
left.
The programme is shown in the numerical keypad displays at
the front left and rear left. Example:
Programme 3 = front left 3, rear left 0
Programme 14 = front left 4, rear left 1
The status is shown in the numerical keypad display at the
rear right.
To call up programming mode
^ With the hob switched off, touch the s and $ sensors at
the same time until the safety lock indicator lamp flashes.
To set the programme setting
^ To set the units position touch the relevant number on the
front left numerical keypad.
^ To set the tens position touch the relevant number on the
rear left numerical keypad.
To set the status setting
^
Touch the appropriate number on the front right numerical
keypad.
To save settings
^
Touch the s sensor until all the displays go out.
To not save settings
^
Touch the $ sensor until all the displays go out.
Programming
42