You can change the default settings of the programme
options (see chart). Several settings can be altered in
succession.
After selecting programming mode, P (Programme) and S
(Status) will appear in the timer display. On hobs with 3
cooking zones, an additional indicator will appear at the rear
left.
The programme is shown in the cooking zone displays at the
front left and rear left. Example:
Programme 03 = front left 0, rear left 3
Programme 14 = front left 1, rear left 4
The status is shown in the front right cooking zone display.
To select programming mode
^ With the hob switched off, touch the s and $ sensors at
the same time until the safety lock indicator lamp flashes.
To set the programme
^ To set the units position first touch the sensor for selecting
the rear left cooking zone and then touch the relevant
number on the numerical keypad.
^ To set the tens position first touch the sensor for selecting
the front left cooking zone and then touch the relevant
number on the numerical keypad.
To set the status
^
Touch the sensor for selecting the front right cooking zone
and then touch the relevant number on the numerical
keypad.
To save settings
^
Touch the s sensor until all the displays go out.
To not save settings
^
Touch the $ sensor until all the displays go out.
Programming
50