Filter
Top Products
^
Mark the distance X on the back-side
of the custom door.
^
Also calculate and mark the center of
the custom door Y.
^ Remove the mounting frame from the
appliance door and position it
according to the markings on the
custom door.
^ Pre-drill the holes.
^ Tightly screw on the bracket using
the pre-drilled holes:
Attach the bracket to each
attachment point with at least one
screw.
^
Attach the bracket at the top with at
least 5 screws:
The bracket includes a variety of holes
for the various design options of
custom doors.
When performing any work on the
custom door, always observe the
following:
–
Always select the best load-bearing
surface of the custom door as the
location for screws.
–
Select a screw length that is shorter
than the thickness of the door front.
Attaching and aligning the
custom door front
^
Fit the door handle to the custom
door.
Note that the screws are applied from
the reverse side.
^
Open the upper door and hang the
custom door with the adjusting rail
over the double-threaded bolts p.
^
Screw the nuts q a few turns onto
the double-threaded bolts. Do not
tighten completely.
^
Close the door.
Installation
54