Filter
Top Products
Operation
Short step system
Touchpads 1, 2, and 3 allow you to
store in memory programmes which
you frequently use.
There are three memory stores where
frequently used programmes can be re-
corded.
You can store all the operating function-
s, e.g. grilling, combination functions,
and automatic programmes.
You can also store the command to
switch the turntable function on or off.
Each memory store can be used again
with a different programme.
Proceed as for setting the operating
mode.
Do not however press the START but-
ton at the end, instead select one of
the three programmes 1, 2, or 3 and
store the setting.
The code number of the stored pro-
gramme will appear in the display.
Finally press touchpad C to confirm
the setting.
The time of day appears in the dis-
play area.
Calling up the "Short step system"
Press the relevant storage touchpad,
1,2 or 3.
The stored settings for the operating
function appear in the display area.
The symbol for the function flashes
and the number of the programme
store appears.
Press the START button.
In the display area the codes for the
operating functions appear and the
time counts down in one second
steps. An audible tone sounds at the
end.
If you press the START button immedi-
ately after selecting the programme 1,
2, or 3, this will avoid the whole se-
quence showing in the display area.
Storing a new programme will auto-
matically delete any previously
stored programme.
In the event of a power cut the
stored programmes will be deleted,
and will need to be re-entered.
Make a note of the programme se-
quences, so that they are available
for use when you need them.
Operation
26